Vertical Into Class A Chimney; Through The Wall & Vertical-Exterior; Vertical-Interior - Quadra-Fire MTVERNON-AE-MBK Owner's Manual & Installation

R
C. Vertical into Existing Class A Chimney
Flashing
Firestop
Ceiling Support
6 in.
(152mm)
Min.
Non-combustible Hearth Pad
Figure 15.1
D. Through The Wall & Vertical - Exterior
2 in. (51mm) minimum
6 in. (152mm)
minimum
Figure 15.2
September 1, 2008
Rain Cap
12 in. (305mm) Minimum
6 in. (152mm) Class A
Chimney Connector
Adapter
3 in. (76mm) Min.
3 to 3 in.
(76-76mm)
Top Vent Kit
Clean-out Cover
Rain
Cap
12 in.
Flashing
(305mm)
minimum
Support
Bracket
every 60 in.
(1524mm)
Wall Thimble
Tee
Clean-out
Cover
Non-combustible Hearth Pad
We recommend a minimum of 60 inches
(1524mm) vertical, however above the eave
is preferred.
All three installations are approved for mobile
home installations. Must use 3 or 4 inch (76
to 102mm) "L" or "PL" Listed pellet venting or
Listed double wall pipe and Quadra-Fire Out-
side Air Kit in mobile homes. Single wall pipe
is approved for residential installations only.
*NOTE: Clearance to combustibles are for
standard pellet pipe. If pellet pipe manufac-
turer allows reduced clearances to their pipe,
reduced clearances are allowed.
3 to 6 in. (76-152mm)
Offset Adapter
E. Vertical - Interior - Typical Installation
Firestop
6 in.
(152mm)
Min.
Non-combustible Hearth Pad
Figure 15.3
7034-106E
Mt. Vernon Pellet Stove (AE)
Rain Cap
12 in.
Flashing
(305mm)
Minimum
3 in. (76mm) Min.
3 in. to 3 in.
(76-76mm)
Top Vent Kit
Clean-out Cover
Page 15