Switch To The Target Image By Remote Control - Epson EB-G5950 User Manual

Changing the Projected Image
When switching to LAN, images from computers connected through the
network are projected. (EB-G5950/G5650W only)
The following screen showing the status of image signals remains
q
displayed when only the image that the projector is currently
displaying is available, or when no image signal can be found. You can
select the input port where the equipment you want to use is
connected. If no operation is performed after about 10 seconds, the
screen closes.
Example: EB-G5950/G5650W

Switch to the Target Image by Remote Control

You can change directly to the image from the target input port by pressing
the following buttons on the remote control.
When switching to LAN, images from computers connected through the
network are projected. (EB-G5950/G5650W only)
"Remote Control" p.16
s
28