Switch To The Target Image By Remote Control - Epson EB 824 User Manual

Changing the Projected Image
The following screen showing the status of image signals is
q
displayed when only the image that the projector is currently
displaying is available, or when no image signal can be found. You
can select the input port where the equipment you want to use is
connected. If no operation is performed after about 10 seconds, the
screen closes.
USB is only displayed for EB-826W/825/824/85.
LAN is only displayed for EB-826W/825/85.

Switch to the target image by Remote Control

You can change directly to the target image by pressing the following
buttons on the Remote Control.
A
Each time the button is pressed, the image changes from the Computer1
input port to the Computer2 input port.
B
Each time the button is pressed, the image changes from the Video input
port to the S-Video input port.
C
Each time the button is pressed, it changes to the image from equipment
connected to USB Display/USB port (TypeA). Only changes to USB
Display when using the EB-84.
D
When the projector is connected to a computer via a network, you can
switch to images projected from EMP NS Connection.(EB-826W/825/85
only)
When using EB-824/84, this does not function even if the button is pressed.
Remote Control
17