Switch To The Target Image By Remote Control - Epson EB-Z8050W User Manual

Changing the Projected Image
The following screen showing the status of image signals is
q
displayed when only the image that the projector is currently
displaying is available, or when no image signal can be found. You
can select the input port where the equipment you want to use is
connected. If no operation is performed after about 10 seconds, the
screen closes.
LAN is displayed on the screen only when using EB-Z8050W.

Switch to the target image by Remote Control

You can change directly to the target image by pressing the following
buttons on the Remote Control.
A
Changes to images from the Computer input port.
B
Changes to images from the Video input port.
C
Changes to images from the S-Video input port.
D
Changes to images of EasyMP Network Projection. (EB-Z8050W only)
This button does not function when using EB-Z8000WU.
E
Each time the button is pressed, the image displayed changes between the
DVI-D and HDMI input ports.
F
Changes to images from the BNC input port.
Remote Control
22