M O Indicator Is Flashing Or Lit - Epson EB-G5950 User Manual

Problem Solving
Status
Indicator is flashing or lit
m o
Status
Cause
Lamp Error Check the following two points.
• Take out the lamp and check whether it is cracked. s
Lamp Failure
• Clean the air filter. s
Lamp Cover Open
If it is not cracked: Re-fit the lamp and turn on the power.
If the error continues: Replace the lamp with a new lamp and turn on the power.
If the error continues: Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local
dealer or the nearest address provided in the Support and Service Guide. s
If it is cracked: Replace it with a new lamp, or contact your local dealer for further advice. If replacing the lamp yourself, be
careful to avoid pieces of broken glass (you cannot continue projecting until the lamp is replaced). s
List
When using at an altitude of 1500 m or more, set High Altitude Mode to On. s
Check that the lamp cover and the lamp are securely installed. s
If the lamp cover or the lamp is not securely installed, the lamp does not switch on.
Power Err. (Ballast) Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest
address provided in the Support and Service Guide. s
Cause
High Temp Warning (This is not an abnormality. However, if the temperature rises too high again, projection stops automatically.)
• Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.
• If the air filter is clogged, clean or replace it. s p.101,
Replace Lamp Replace it with a new lamp. s
If you continue to use the lamp after the replacement period has passed, the possibility that the lamp may explode increases.
Replace it with a new lamp as soon as possible.
Remedy or Status
p.104
p.101
Epson Projector Contact List
: Lit : Flashing : Off
Remedy or Status
p.107
p.104
Epson Projector Contact List
Epson Projector Contact
p.61
p.104
: Varies according to the projector status
89