Adjusting the Projected Image
F
When you are done, press the [Esc] button to exit the
correction menu.
Because the correction method was changed to Quick Corner from
Keystone in the configuration menu, when [
and [
/ ] buttons are pressed later, the screen for selecting the
>
corner in procedure 2 is displayed. Change Keystone from the
configuration menu to H/V-Keystone if you want to correct H/V-
Keystone when pressing the [
buttons on the control panel.
If the [Esc] button is held down for about two seconds while
q
correcting with Quick Corner, the following screen is displayed.
Reset Quick Corner: Resets the result of Quick Corner corrections.
Switch to H/V-Keystone: Switches the correction method to H/V-
Keystone. s "H/V-Keystone"
H/V-Keystone
Procedure
Press the [
/
], [
/
], [
w
v
panel to adjust keystone settings in the horizontal and vertical
directions independently.
/
], [
/
w
v
/
], [
/
], [
/ ] and [
w
v
<
p.59
s
p.25
/ ] and [
/ ] buttons on the control
<
>
This adjustment can also be made from H/V-Keystone on the Settings
q
menu. s
], [
/ ]
<
• Correcting vertical keystone
Vertical keystone can be corrected to a vertical projector tilt of up to 40˚
against the screen. If you use the projector tilted at an angle of more than
30˚ it could be damaged and cause an accident.
/ ]
>
If the [
/
] and [
w
1 second, the value of vertical keystone will return to the original status.
p.59
/
] buttons are pressed simultaneously for at least
v
25