Connecting The Power Supply - Lionel AMC/ARC Log Loader Owner's Manual

Connecting the power supply

Y our Log Loader was designed to operate at 16-18 volts (AC). The power supply terminals are
located along the side of the controller. Refer to Figure 2. Please note that the ends of the
wires must be stripped back 1/8" to 1/4".
Only an adult should perform this task. We recommend using a pair of wire
Caution!
strippers.
1. Attach one wire to the Power/A terminal on the power supply and connect it to the terminal
labeled A on the underside of the controller.
To make the controller connections, loosen the terminal locks using a small phillips-
Note!
head screwdriver and insert the bare ends of the wires into the holes in the housing.
Tighten the terminal locks to secure the connection.
2. Attach another wire to the Common/Ground/U terminal on the power supply and connect it
to the terminal labeled U on the underside of the controller.
Figure 2. Power connections
A A
U U
Ax- COM
Ax+ DAT
4