Table of Contents
Advertisement
Joining the MagneLock track sections
L
ionel's MagneLock Track allows you to assemble your track in seconds! Just hold the pieces near
each other and magnets will align and hold the sections together. Metal rail joiners are not neces-
sary between the sections as the connectors in the roadbed will transfer power. If you would like to add
these connectors for extra alignment and conductivity, or if you would like to join MagneLock Track
to other HO tracks, simply break away the alignment tabs on the ends of the rails and insert the rail
joiners. Lionel HO MagneLock Track is compatible with HO code 83 rail track from other manufac-
turers.
While not necessary, if you would like to fasten your track permanently to a platform, small holes
are provided in the roadbed for nails. Metal tabs on the underside of the roadbed can be used to solder
additional feeder wires if desired.
Figure 1. Joining the track sections
Connecting your wall-pack power supply
Y
our trains are powered by a DC wall-pack power supply. To power the track, simply plug the
wall-pack into an outlet and plug the jack into the terminal section as shown in Figure 2.
Figure 2. Wall-pack power supply connection
Jack on wall-pack
power supply
5
Advertisement
Table of Contents
