Connecting The Log Loader For Operation In The Trainmaster Command Control Environment - Lionel AMC/ARC Log Loader Owner's Manual

Connecting the Log Loader for operation in the TrainMaster Command
Control environment
T o operate the Log Loader using your CAB-1 Remote Controller (available separately,
6-12868), you must connect the Crane to the Command Base (available separately, 6-12911).
The Command Base will transmit your CAB-1 Remote Control commands to this accessory.
If you have no other TMCC Controllers connected, you will need to wire the Log Loader to the
Command Base using a Command Base Cable (available separately, 6-14191 or 6-14195). If
you have other TMCC Controllers connected, you will need to "daisy chain" the Controllers, or
wire them one after another, using a Controller to Controller Cable (available separately,
6-14193, 6-14196, or 6-14197). Refer to Figure 4.
• If you are using the Command Base Cable, simple plug the cable into the COMPUTER port
on the Command Base. Connect the red wire to the DAT terminal on the Log Loader. Finally,
connect the green wire to the COM terminal on the Log Loader.
• If you have other TMCC Controllers already connected to your Command Base, simply
connect the DAT terminals with the red wire and the COM terminals with the green wire
from the Controller to Controller Cable.
Figure 4. Daisy chain
UNDERSIDE OF
THE CRANE
CONTROLLER
6
A/C
POWER
SUPPLY
A U