Replacing your locomotives’ lamps Replacing the passenger car lamps Limited Warranty/Lionel Service The following Lionel marks may be used throughout this instruction manual and are protected under law. All rights reserved. Lionel®, American Flyer® TrainMaster®, Odyssey®, RailSounds™, CrewTalk™, TowerCom™, DynaChuff™, StationSounds™, Pullmor®, ElectroCoupler™, Magne-Traction®, CAB-1 Remote...
The curves must have a radius of at least 20”. Power up your locomotive with your transformer. Your locomotive is designed to operate on 9-15 volts alternating current. Virtually all American Flyer and Lionel alternating-current transformers are suitable. Move ‘em out! Get your locomotive moving.
POWER SUPPLY Black wire Power/A Lionel no. 610-5906-001 Sound Activation Button for activating the bell Figure 2. Sound Activation Button wiring The no. 610-5906-001 button works with any Lionel or American Flyer AC Note! transformer except no. 6-4690 Type MW.
Lionel Lubrication and Maintenance Kit To grease the axles, remove the truck (no. 6-62927), available from your Lionel frame by removing two Phillips screws from the truck. Using an artist’s paint brush or dealer.
To replace a socket. Replace it with Lionel part lamp, remove the five chassis screws from the no. 600-8352-311. To reassemble, reverse the underside of the frame (see Figure 3 on procedure.
Maintaining and servicing your set Replacing the passenger car lamps ach of the passenger cars is illuminated by one lamp, Lionel part no. 600-0057-300. During the course of normal operation, these lamps may require replacement. Follow these steps and refer to Figure 5 as you replace the lamps.
Center, together with proof of original purchase above instructions carefully before returning any will, at the option of Lionel L.L.C., be repaired or merchandise for service. You may choose to have replaced, without charge for parts or labor. In the...
Need help?
Do you have a question about the American Flyer and is the answer not in the manual?
Questions and answers