Resetting the Log Loader in the TrainMaster Command Control
environment
T
o reset your Log Loader in the TrainMaster Command Control environment, simply remove
the run/program jumper, press H on the CAB-1 Remote Controller, and then replace the
jumper. Alternately, you may follow the conventional reset procedure as discussed on page 6.
CAB-1 Remote Controller commands
Operates the stakes.
Turns off the chain drive.
Turns on the chain drive.
Turns on the lights.
Turns off the lights.
Activates the keypad.
Removes a loop.
Loops a recording.
Starts recording.
Discontinues playback. Any functions in operation will
continue to operate. Use the CAB-1 Remote Controller or
the controller to turn off the specific function.
Plays the recording. Pauses playback. Any functions in operation will continue to operate. Use
the CAB-1 Remote Controller or the controller to turn off the specific function.
11