Lionel AMERICAN FLYER EP-5 Owner's Manual

Lionel AMERICAN FLYER EP-5 Owner's Manual

Electric locomotive

Advertisement

Quick Links

74-8075-250
10/08
EP-5
Electric Locomotive
Owner's Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AMERICAN FLYER EP-5 and is the answer not in the manual?

Questions and answers

Summary of Contents for Lionel AMERICAN FLYER EP-5

  • Page 1 74-8075-250 10/08 EP-5 Electric Locomotive Owner’s Manual...
  • Page 2 Maintaining and servicing your locomotive Lubricating your locomotive Replacing your locomotive’s lamps Notes Limited Warranty/Lionel Service The following Lionel marks may be used throughout this instruction manual and are protected under law. All rights reserved. Lionel , TrainMaster , Odyssey...
  • Page 3: Transformer Operations

    The curves must have a radius of at least 20”. Power up your locomotive with your transformer. Your locomotive is designed to operate on 6-18 volts alternating current. Virtually all American Flyer or Lionel alternating-current transformers are suitable. Do not power your locomotive with direct current (DC).
  • Page 4: Locking Your Locomotive Into A Single Operational State

    Transformer operations Locking your locomotive into a single operational state o select a single operational state for your locomotive (for example, forward only), you can deactivate the reverse unit’s sequencing function with the DIRECTION CONTROL switch. Get your locomotive moving in the desired direction, then slow it down without stopping. Set the DIRECTION CONTROL switch to OFF.
  • Page 5: Coupler Operation

    Coupler operation Using your locomotive’s couplers ush up on the uncoupling weight located directly under the coupler to open the coupler. Refer to Figure 2. To couple two cars together, place them on the track with at least one of the couplers open, then slide them together.
  • Page 6: Operating The Trainsounds Sound System

    8. Transformers produced by other manufacturers may not be capable of activating Note! this feature. We recommend using a Lionel 610-5906-001 Sound Activation Button (included with this locomotive) if the HORN button on your transformer does not work.
  • Page 7: Adjusting The Volume

    Operating the TrainSounds sound system Adjusting the volume se the volume control knob on the underside of the locomotive to adjust the volume. Swivel the truck to access the knob. Use a flat bladed screwdriver to rotate the volume control knob. Refer to Figure 3. REAR Volume control knob­...
  • Page 8: Installing A Lionel Sound Activation Button For Conventional Operation

    Installing a Lionel Sound Activation Button for conventional operation f your transformer lacks WHISTLE/HORN and BELL buttons, you will need to install Lionel no. 610-5906-001 Sound Activation Buttons (included with this locomotive) to activate the locomotive’s horn and bell sounds.
  • Page 9: Maintaining And Servicing Your Locomotive

    We recommend that you purchase a Lionel Lubrication and Maintenance Kit (6-62927), available from your Lionel dealer. Two basic rules to keep in mind: never over-lubricate (a small amount will do), and avoid getting grease or oil on the locomotive’s wheels or your track.
  • Page 10: Replacing Your Locomotive's Lamps

    Lionel part no. 640-8075-330. During the course of normal operations, you may find that these lamps require replacement. Replacement lamps are available from your authorized Lionel Service Center or from Lionel Service. To replace the lamps, remove the four body screws from the underside of the frame and lift away the body.
  • Page 11 Notes...
  • Page 12 (requires proof of purchase from the Lionel Authorized Retailer* it was originally purchased). Any products on which warranty service is sought must be sent freight or postage prepaid (Lionel will refuse any package when postage is due). Transportation and shipping charges are not covered as part of this warranty.

Table of Contents