Connecting Your Uncoupling Track Section To An Auxiliary Power Supply - Lionel Fastrack Owner's Manual

Connecting your Uncoupling Track section to an auxiliary power
supply
Y ou may choose to power your Uncoupling Track section with a separate power supply using
an Accessory Power Wire with quick connectors (available separately, 6-12053). This will
allow you to uncouple or operate your rolling stock with track power off. Refer to Figure 6 as
you make the power supply connections.
Note!
Do not use the accessory terminals on your track power supply.
1. Attach the quick connectors at the end of the Accessory Power Wire (available separately,
6-12053) to the AUX IN and AUX GND tabs on the underside of the Uncoupling Track
section.
2. Connect the bare ends of the Accessory Power Wire to the Power/A and Common Ground/U
terminals on your power supply.
3. Move the quick connector at the end of the controller cable from the tab labeled TRK PWR to
the tab labeled AUX PWR.
4. Turn on your power supply when you are ready to operate the track section using the
controller. Note that the power supply must be set at 10-12 volts.
Figure 6. Power supply connections
Controller button
8
POWER
SUPPLY
A U
TRK PWR
AUX PWR
AUX IN
AUX GND