Assigning An Id Number To Your Log Loader - Lionel AMC/ARC Log Loader Owner's Manual

Assigning an ID number to your Log Loader

P repare your Log Loader for operation in the TrainMaster Command Control environment by
assigning a unique engine (ENG) ID number to it. The Log Loader will only respond to
commands that are intended for this ID number.
1. Using a needle nose pliers, remove the RUN/PROGRAM jumper from the bottom of the
controller. Refer to Figure 5 for the location of the jumper.
2. Press the ENG button on your CAB-1 Remote Controller.
3. Select a unique ID number (0-99) and enter it with the CAB-1 Remote Controller's numeric
keypad.
4. Press SET on your CAB-1 Remote Controller.
5. Replace the RUN/PROGRAM jumper from the underside of the controller.
Figure 5. Jumper location
7