Advanced Operations: Connecting Your Uncoupling Track Section To An Auxiliary Power Supply - Lionel New York Central Flyer Owner's Manual

Maintaining and servicing your set
Advanced operation: connecting your Uncoupling Track section to
an auxiliary power supply
Y
ou may choose to power your Uncoupling Track section with a separate power supply using an
Accessory Power Wire with quick connectors (available separately, 6-12053). This will allow you
to uncouple or operate your rolling stock with track power off. Refer to Figure 14 as you make the
power supply connections.
Note!
Do not use the accessory terminals on your track power supply.
1. Attach the quick connectors at the end of the Accessory Power Wire (available separately,
6-12053) to the AUX IN and AUX GND tabs on the underside of the Uncoupling Track section.
2. Connect the bare ends of the Accessory Power Wire to the Power/A and Common Ground/U termi-
nals on your power supply.
3. Move the quick connector at the end of the controller cable from the tab labeled TRK PWR to the
tab labeled AUX PWR.
4. Turn on your power supply when you are ready to operate the track section using the controller.
Note that the power supply must be set at 10-12 volts.
Figure 14. Power supply connections
Controller button
21
POWER
SUPPLY
A U
TRK PWR
AUX PWR
AUX IN
AUX GND