Making A Simple Recording With The Log Loader - Lionel AMC/ARC Log Loader Owner's Manual

Making a simple recording with the Log Loader

F ollow these steps to create a simple recording with the Log Loader. As you use your CAB-1
Remote Controller to operate the Log Loader, the accessory will memorize each command.
After you press AUX1, 9, you have 45 seconds to create a recording.
A CAB-1 Remote Controller and Command Base are required to make a recording.
Note!
Plan your recordings before you begin. Remember—the accessory will memorize
Hint!
every command, including the unintentional ones. If you make a mistake, just start
over. You can always record over a program.
1. Remove the RUN/PROGRAM jumper from the bottom of the controller. Refer to Figure 5 on
page 7 for the location of the jumper.
2. Press ENG and enter the Log Loader's ID number.
When creating a recording, the LED will blink on for one second and off for one
Note!
second.
3. Press AUX1, 9 on the CAB-1 Remote Controller to start recording.
4. Operate the accessory.
5. Press AUX1, 0 to end the recording.
6. Replace the jumper.
9