Playing The Recording; Looping" The Recording; Removing A Loop - Lionel AMC/ARC Log Loader Owner's Manual

Playing the recording

Follow these steps to play your recording.
Always keep the starting point (the initial position of the Log Loader) and the input
Hint!
voltages the same. We recommend that you start with the Log Loader stopped. Before
you play the recording, be sure to position the accessory where it was when you
started to record for more consistent results.
1. Press ENG and enter the Log Loader's ID number.
2. Press AUX2 on the CAB-1 Remote Controller to play the recording. Press AUX2 again to
pause the recording.
3. Press AUX1, 0 to discontinue the recording at any time during playback.

"Looping" the recording

You may choose to have the recording "loop," or play repeatedly. Keep in mind that the loop
command is not a part of the actual recording; therefore, this function can be turned on or off at any
time. Follow these steps to create a loop after you have made the recording.
Note!
Do not remove the jumper.
1. Press ENG and enter the Log Loader's ID number.
2. Press AUX1, 8 on the numeric keypad.
3. Press SET on the CAB-1 Remote Controller.

Removing a loop

Because the looping function is not a part of the recording, you can remove it at any time without
erasing your recording.
Note!
Do not remove the jumper.
1. Press ENG and enter the Log Loader's ID number.
2. Press AUX1, 7 on the numeric keypad.
3. Press SET on the CAB-1 Remote Controller.
10