Hangar 9 Alpha.60 ARF Assembly Manual page 34

Step 28
Once the throttle servo has been adjusted, install the
nylon wire clevis and screw in the servo arm.
Step 29
Place a clevis retainer onto a clevis. Thread the clevis
12 turns onto the 3/32" x 5" aileron pushrod wire.
Step 30
Thread a nylon control horn onto the aileron control
wire. Adjust the horn so it is 1" from the surface of
the wing.
Step 31
Drill the outer hole in the aileron servo arm using
a 5/64" drill bit.
34
Section 10: Control Linkage Installation
Step 32
Secure the aileron pushrod wire to the servo arm
using a nylon wire keeper.
Step 33
Attach the clevis to the aileron control horn.
Step 34
With the radio on, check to make sure the aileron is
in line with the center area of the wing. If not, thread
the clevis in or out on the pushrod wire until the
aileron and wing are in alignment.
Step 35
Repeat Steps 29 through 34 for the remaining
aileron linkage.
Step 36
Install the screw in the servo arm to secure it
to the servo.