Hangar 9 Alpha.60 ARF Assembly Manual page 30

Step 15
Locate the 3/32" x 29 3 / " rudder pushrod
4
wire inside of the fuselage.
Step 16
Install the rudder control horn using three 2mm x
18mm screws.
Step 17
Place a clevis retainer onto a clevis. Thread the clevis
12 turns onto the rudder pushrod wire.
Step 18
Drill the outer hole in the rudder servo arm using a
5/64" drill bit.
30
Section 10: Control Linkage Installation
Step 19
Secure the rudder pushrod wire to the servo arm
using a nylon wire keeper.
Step 20
Attach the clevis to the center hole on the rudder
control horn.