Hangar 9 Alpha.60 ARF Assembly Manual page 22

Step 3
Slide the wire into the steering pushrod tube.
Position the steering arm in the nose gear mount.
Step 4
Slide the nose gear wire into the nose gear mount
and steering arm. Note that there is a flat area on the
nose gear. This faces the front of the plane.
22
Section 8: Landing Gear Installation
Step 5
Apply a drop of threadlock on the 3mm x 8mm screw.
Install the screw into the hole in the front of the
steering arm. Tighten the screw onto the flat on the
nose gear wire.
Step 6
Position the main landing gear on the fuselage.
The straight edge of the main landing gear faces
towards the front of the fuselage. Secure the main
gear using two 4mm x 18mm screws. Remember to
use threadlock to prevent the screws from loosening
during flight,