Hangar 9 Alpha.60 ARF Assembly Manual page 31

Section 10: Control Linkage Installation
Step 21
With the radio on, use a straight edge to make sure
the rudder is in line with the fin. If not, thread the
clevis in or out on the pushrod wire until the rudder
and fin are in alignment.
Step 22
Install the screw in the servo arm to secure it
to the servo.
Step 23
Locate the prebent 15 3 / " throttle pushrod wire. Place
4
a clevis retainer onto a clevis. Thread the clevis
12 turns onto the throttle pushrod wire. Slide the
pushrod wire into the fuselage.
Step 24
Drill both holes next to the fuselage in the throttle
servo arm using a 5/64" drill bit.
31