Hangar 9 Alpha.60 ARF Assembly Manual page 29

Section 10: Control Linkage Installation
Step 11
Drill a 3/32" hole in the outer hole in the rudder
servo arm as shown.
Step 12
Remove the servo arm. Slide the brass wire connector
into the hole. Secure the connector using the nylon
connector keeper.
Step 13
Slide the steering wire through the brass wire
connector. Place the servo arm back onto the
rudder servo.
Step 14
Position the nose wheel so it is in line with the
centerline of the fuselage. Use a 3mm x 5mm screw
to secure the steering pushrod wire.
Note: If your plane does not track straight
on the runway, loosen the screw and adjust
the nose wheel. Changing the rudder trim
will change the steering trim, but will trim
the rudder also. Use the trim for in-flight
adjustments, and the screw for steering.
29