Hangar 9 Alpha.60 ARF Assembly Manual page 19

Step 9
Trace the outline of the fuselage onto the bottom of
the stabilizer using a felt-tipped pen.
Step 10
Remove the covering from the bottom of the stabilizer
using a hobby knife or soldering iron.
Note: Remove the covering from the rear of
the stabilizer up to the bolt as shown.
Section 7: Tail Installation (Glue Attachment Option)
Note: Read through and understand Steps 11
through 14 before mixing any epoxy.
Step 11
Mix 1/2 ounce of 30-minute epoxy. Apply the epoxy
to the exposed wood on the bottom of the stabilizer.
Step 12
Place the stabilizer/fin assembly back onto the
fuselage. Slide a #4 washer onto a 4-40 x 3/4" screw.
Apply a drop of threadlock to the screw. Prepare two
screws using this method.
19