Hangar 9 Alpha.60 ARF Assembly Manual page 12

Section 5: Radio Installation
Step 3
Position the three servos as shown. Use the screws
provided with the servos to secure them in position.
Step 4
Cut one of the flat foam pieces to a length of 5
Place the foam piece inside the fuselage as shown.
12
Step 5
Plug the servos, receiver and aileron extension into
the receiver. Use the radio instructions to make sure
the servos are plugged into the correct channels. Use
the photo in Step 3 that labels the elevator, rudder
and throttle servos.
1 / ".
2
Step 6
Cut pieces of the remaining foam to fit at the front
and rear of the radio area. Place the receiver and
receiver battery onto the foam as shown. Position
the servo wires so they are neat and not cluttering
the area around the receiver and receiver battery.
Use the remaining foam to insulate the receiver and
receiver battery from the sides of the fuselage and
from each other.