Hangar 9 Alpha.60 ARF Assembly Manual page 27

Section 10: Control Linkage Installation
Step 5
Place a clevis retainer onto a clevis. Thread the clevis
12 turns onto the elevator pushrod wire.
Step 6
Drill the outer hole in the elevator servo arm using
a 5/64" drill bit.
Step 7
Secure the elevator pushrod wire to the servo arm
using a nylon wire keeper.
Using the nylon wire keepers is simple,
and they provide an excellent way to attach
pushrod wires to servo arms.
The first step is to have a 90-degree bend in
the pushrod wire. For the Alpha™ trainer, there
90-degree bends have already been made.
Install the bend into the servo arm. In most
cases a hole will need to be drilled in the
servo arm that the wire can fit through.
Place the nylon wire keeper onto the end of
the pushrod wire that passes through the
servo arm.
27