Removing/Installing The Surestep Spring; Removing; Installing; Removing/Installing The Walking Beam - Invacare Pronto M50 Service Manual

Removing/Installing the SureStep Spring

NOTE: For this procedure, refer to FIGURE 10.6.

Removing

1. Unhook the SureStep spring from the hooks on the walking beam and the frame.

Installing

1. Position the SureStep spring on the hook on the frame.
2. Position the top of the SureStep spring onto the hook on the walking beam.
Hook
Walking
Beam
SureStep Spring
Hook
FIGURE 10.6 Removing/Installing the SureStep Spring

Removing/Installing the Walking Beam

NOTE: For this procedure, refer to FIGURE 10.7 on page 94.
Removing
1. Remove the front headtube assembly. Refer to Removing/Installing the Front
Headtube Assembly on page 83.
2. Unhook the top of the SureStep spring from the hook on the walking beam.
3. Remove the shoulder screw and locknut securing the walking beam to the frame
bracket.
4. Remove the walking beam from the frame.
Installing
1. Position the walking beam into the frame bracket.
2. Secure the walking beam to the frame using the shoulder screw and locknut. Torque
to 23 ft-lbs ± 20%.
Part No. 1125075
Frame
93
SECTION 10—SHROUDS AND FRAME
Pronto® Series