Adjusting The Headrest (Semi-Recline Only); Removing/Installing The Seat Assembly; Removing; Installing - Invacare Pronto M50 Service Manual

SECTION 6—VAN SEAT
Seat Hinge
DETAIL "A"
Locknut
105°
110°
100°
95°
Shoulder
Shoulder
Bolt
Bolt
FIGURE 6.2 Adjusting the Back Angle - Fold Down Back Angle

Adjusting the Headrest (Semi-Recline Only)

NOTE: For this procedure, refer to FIGURE 6.3.
1. To raise the headrest, lift the headrest up to the desired position.
2. To lower the headrest, push the release tab towards the front of the wheelchair. Lower
the headrest to the desired position.
Headrest
Release Tab
Headrest
Tube
FIGURE 6.3 Adjusting the Headrest (Semi-Recline Only)

Removing/Installing the Seat Assembly

NOTE: For this procedure, refer to FIGURE 6.4 on page 51.

Removing

1. Disconnect the joystick. Refer to Disconnecting/Connecting the Joystick on page 123.
2. Fold down the seat back.
3. Pull the seat lever up and lift the seat assembly up and away from the seat post.

Installing

1. Align the seat pivot with the seat post.
2. Pull the seat lever up and lower the seat assembly on the seat post.
50
Pronto® Series Part No. 1125075