NOTE: If necessary, slightly twist seat assembly back and forth to lock it in place.
3. Release the seat lever.
4. Pull the seat assembly up to ensure that it is locked in place.
5. Connect the joystick. Refer to Disconnecting/Connecting the Joystick on page 123.
NOTE: Office style van seat
is shown. Standard van seat
installs the same way.
FIGURE 6.4 Removing/Installing the Seat Assembly
Adjusting Seat Depth
NOTE: For this procedure, refer to FIGURE 6.5 on page 52.
1. Remove the seat. Refer to Removing/Installing the Seat Assembly on page 50.
2. Perform one of the following:
• For Standard Van Seat -
i. Remove the seat base from the seat assembly. Refer to Adjusting Seat Position
on Seat Base on page 56.
ii. Go to STEP 3.
• For Office Style Seat - Go to STEP 3.
3. Remove the six mounting screws located under the seat that secure the seat back
assembly in place.
4. Adjust seat back assembly to desired position and reinstall the six mounting screws.
Securely tighten.
Part No. 1125075
Seat Lever
Seat
Assembly
51
SECTION 6—VAN SEAT
Seat Post
Pronto® Series