Section 7-Asba Seat; Removing/Installing The Seat Assembly; Removing; Installing - Invacare Pronto M50 Service Manual

SECTION 7—ASBA SEAT
SECTION 7—ASBA SEAT
WARNING
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the Off position.

Removing/Installing the Seat Assembly

NOTE: For this procedure, refer to FIGURE 7.1 on page 60.

Removing

1. Disconnect the joystick. Refer to Disconnecting/Connecting the Joystick on page 123.
2. Fold down the seat back.
3. Pull the seat lever up and lift the seat assembly up and away from the seat post.

Installing

1. Align the seat pivot with the seat post
2. Pull the seat lever up and lower the seat assembly on the seat post.
NOTE: If necessary, slightly twist seat assembly back and forth to lock it in place.
3. Release the seat lever.
4. Pull the seat assembly up to ensure that it is locked in place.
5. Connect the joystick. Refer to Disconnecting/Connecting the Joystick on page 123.
59
Part No. 1125075 Pronto® Series