Section 4-Wheelchair Operation; Turning The Power On/Off; M50 And M51 Wheelchairs Manufactured Before 8/15/05 - Invacare Pronto M50 Service Manual

SECTION 4—WHEELCHAIR OPERATION
SECTION 4—WHEELCHAIR
OPERATION
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Set-up of the Electronic Control Unit is to be performed only by a qualified
technician. The final adjustments of the controller may affect other activities of the
wheelchair. Damage to the equipment could occur if improperly set-up or adjusted.

Turning the Power On/Off

M50 and M51 Wheelchairs Manufactured Before 8/15/05

NOTE: For this procedure, refer to FIGURE 4.1.
1. Turn the power On by moving the On/Off switch up or down. The switch
automatically retracts back to center position.
NOTE: After turning power On, all indicators
will light briefly and the display gauge will
indicate one of the following:
• The Current Battery Charge -
Information gauge shows all LEDs lit
or partial LEDs lit. Refer to table in
Information Gauge Display on page 40.
• Out Of Neutral At Power Up -
Information Gauge shows all LEDs
flashing slowly. This occurs when the
power is turned On when the joystick is
out of neutral. This feature prevents
sudden and unexpected movements of
the power chair.
2. Turning the power Off can be achieved
by moving the On/Off switch up or
down. The switch automatically
retracts back to center position.
Pronto® Series
WARNING
FIGURE 4.1 Turning the Power On/Off -
M50 and M51 Wheelchairs Manufactured
32
Information
Gauge
INVACARE
ON/OFF
Toggle Switch
Before 8/15/05
Part No. 1125075