Installing And Removing The Seat Plate; Setting Armrest Height - Invacare Aquatec Ocean VIP Ergo User Manual

4.2.4 Installing and Removing the Seat Plate

Installing
1. Place the seat plate on the seat frame with the cutout
to the front.
2. Press the seat plate down with the flat hand at the
sides and then at the front and back until the seat plate
snaps onto the seat frame.
Removing
1. Pull the seat plate upwards at the rear.

4.2.5 Setting Armrest Height

1. Open the belt buckle of the backrest cover which is
passed on the inside of the backrest frame.
2. Open the belt buckle on the backrest cover, which is
above the armrest.
When adjusting to a lower position the belt
beneath the armrest must be opened.
3. Pass this belt on the inside of the backrest frame and
close it again.
1652073-A
4.
Remove cap A.
5. Fold up armrest B to pull it off the armrest bracket C.
6.
Remove screws D from armrest bracket C with supplied
Allen key.
Borem ipsum
A
Fig. 4-1
Fig. 4-2
Setup
15