Servicing - Kubota WSM B1710 Workshop Manual

B1710 · B2110 · B2410 · B2710, WSM

(3) Servicing

Clearance between Tip of Gear Tooth and Casing
1. Measure the clearance between gear and casing at several
points with feeler gauge.
2. If the clearance exceeds the allowable limit, replace the
assembly.
Clearance between tip
Allowable limit
of gear tooth and casing
Clearance between Bushing and Shaft
1. Measure the shaft O.D. with an outside micrometer.
2. Measure the bushing I.D. with a cylinder gauge.
3. If the clearance exceeds the allowable limit, replace it.
Factory spec.
Clearance between
bushing and shaft
Allowable limit
Shaft O.D. Factory spec.
Bushing I.D. Factory spec.
Side Plate Thickness
1. Measure the side plate thickness with an outside micrometer.
2. If the thickness is less than the allowable limit, replace it.
Factory spec.
Side plate thickness
Allowable limit
8-S8
HYDRAULIC SYSTEM
0.15 mm
0.0059 in.
W10130690
0.020 to 0.091 mm
0.0008 to 0.0036 in.
0.12 mm
0.0047 in.
14.970 to 14.980 mm
0.5894 to 0.5898 in.
15.000 to 15.061 mm
0.5906 to 0.5930 in.
W10132840
2.48 to 2.50 mm
0.0976 to 0.0984 in.
2.40 mm
0.0945 in.
W10134390
KiSC issued 11, 2006 A