B2710 - Kubota WSM B1710 Workshop Manual

B1710 · B2110 · B2410 · B2710, WSM

(2) B2710

Draining Transmission Fluid
CAUTION
• Be sure to stop the engine before checking and changing
the transmission fluid.
1. Place oil pan under the tractor.
2. Remove the drain plugs (1) at the bottom of the rear axle case
and oil tank.
3. Drain the transmission fluid and reinstall the drain plugs.
(When refilling)
• Fill new oil from filling port after removing the filling plugs (2) up
to the upper notch on the dipstick (3).
• After running the engine for few minutes, stop it and check the oil
level again, if low, add oil prescribed level.
IMPORTANT
• Use only multi-grade transmission oil. Use of other oils may
damage the transmission or hydraulic system.
Refer to "LUBRICANTS, FUEL AND COOLANT" (See page
G-8).
• Never work the tractor immediately after changing the
transmission oil. Keeping the engine at medium speed for a
few minutes to prevents damage to the transmission.
• Do not mix different blands oil together.
Transmission fluid capacity
(1) Drain Plug
(2) Filling Plug
(3) Dipstick
Rear Wheels
1. Place hydraulic jack under the main frame rear side and jack up
the tractor.
2. Remove the tires.
3. After removing the tires, support the rear axles by stands.
(When reassembling)
Rear wheel mounting
Tightening torque
screw and nut
4-S6
REAR AXLE
15.5 L
4.10 U.S.gals.
3.41 Imp.gals.
a : Oil level is acceptable within this
range
W10123640
108 to 125 N·m
11.0 to 12.8 kgf·m
79.6 to 92.6 ft-lbs
W10129120
KiSC issued 11, 2006 A