Operation; Turning On The Power; Battery Type Selection - Icom IC-F27SR Instruction Manual

■ Turning ON the power

Prior to using the transceiver for the first
time, the battery pack must be fully charged
for optimum life and operation. (p. 19)
Rotate [VOL] to turn ON the power.
➥

Battery type selection

D
The battery type must be selected according to the battery pack or
case when it is changed, but only the first time it is used.
Check the battery type before you begin the selection procedure.
One to three beep(s) sound in sequence, so you must repeat the
steps until the number of beeps matches your battery type.
For example, if your battery type is a Ni-MH battery pack, you must
repeat the procedure until 3 beeps are heard.
Set [ROTARY SELECTOR] to any
q
channel other than Channel 16.
Rotate [VOL] to t
w
transceiver power.
While holding down [PTT], rotate
e
[VOL] to turn ON the power.
• You should hold [PTT] until the bat-
tery type confirmation beeps sound.
( It takes approximately 5 seconds;
while holding down [PTT], the count
down beeps sound. After that, the confirmation beeps sound.)
• 1 beep sounds when the Li-ion battery is selected.
• 2 beeps sound when the battery case is selected.
• 3 beeps sound when the Ni-MH battery is selected.
After the beep sounds, release [PTT].
r
Repeat steps
t
NOTE: This operation may not be available, depending on the
preprogramming. Ask your dealer for details.
urn OFF the
w to r until you select the correct battery type.

OPERATION

[ROTARY SELECTOR]
[PTT]
3
1
2
[VOL]
3
4
5
6
7
8
9
10
11
12
[VOL]
13
14
15
16
17
18
19
20
10