Redundant Configuration; Configuring The Software For Redundancy - HP A1353A User Manual

Redundant configuration

Configuring the software for redundancy

Install the UPS Power Protection Agent on a machine that is power protected by two UPSs. Each UPS
1.
must have a management module installed.
Configure the redundant management server information on the agent.
2.
Open the agent configuration program for your operating system.
a.
—
Windows
—
Linux
—
HP-UX
Enter the correct IP address, host name, communications port, or serial path for the first
b.
management server that should communicate with the agent. Do not select Any Server from the
dropdown box in Windows or enter an asterisk (*) where prompted for Linux or HP-UX.
Enter the correct IP address, host name, communications port, or serial path for the second
c.
management server that should communicate with the agent. Do not select Any Server from the
dropdown box in Windows or enter an asterisk (*) where prompted for Linux or HP-UX.
Close the configuration program.
d.
Configure the agent information on both management servers using the management module web
3.
interface.
Access the web interface through a web browser (on page 41) or the system tray icon (on page
a.
42) in Windows.
Log in to the web interface
b.
appears.
Click the Setup tab in the top frame of the web interface.
c.
Click Attached Devices in the left navigation frame. The Attached Devices screen appears.
d.
If the agent is already attached, click the hyperlink for the agent. The Add / Edit Attached Device
e.
screen appears.
-or-
If the agent is not already attached, click Add New Device. The Add / Edit Attached Device
screen appears.
If the agent has already been added, verify that the IP address or communications port for the
f.
machine that hosts the agent is entered correctly in the Computer Device Information area.
-or-
If the agent has not been added, configure the agent settings. Be sure that the IP address or
communications port for the machine that hosts the agent is entered correctly in the Computer
Device Information area. For more information about adding agents, see "Add / Edit Attached
Device screen (on page 69)."
("Reconfiguring the agent on Windows operating
("Reconfiguring the agent on Linux operating
("Reconfiguring the agent on HP-UX operating
("Signing in to the web
systems" on page 32)
systems" on page 36)
systems" on page 39)
interface" on page 42). The web interface
Redundant configuration 113