Installing The Agent Using The Silent Installation Method - HP A1353A User Manual

Click Finish to close the configurator.
12.
The service starts automatically. Wait until the system tray icon displays a green check mark
begin using the software.
NOTE:
might take a few moments for the icon to change. A green check mark
management module is communicating with the agent without errors. If the service has
stopped, a blue hexagon icon
configured, the UPS is not connected, or the agent and management module are not
communicating. Hover over the icon with the mouse pointer, and a tool tip displays a status
message. For more information about the system tray icon status messages, see "System tray
icon (on page 42)."
NOTE:
Systems

Installing the agent using the silent installation method

Silent installation is typically used by system administrators who have many installations that are
configured identically and require minimal user interaction. During a silent installation you will:
Install an agent through the assisted installation method that is appropriate for the operating system.
Configure the agent exactly as the final replicated systems should be configured.
NOTE:
file for each site. This points each agent to the correct management module and is the more
secure option.
Use the DevManRA.ini file that is generated in the directory of the application as a template in the
agent silent install process.
An icon in the Windows® system tray shows the status of the management module. It
To reconfigure the agent, see "Reconfiguring the agent on Windows® Operating
("Reconfiguring the agent on Windows operating
You must configure the IP address of the management module. Create a DevManRA.ini
appears. A red icon
Installing the HP UPS Power Protection Agent 31
appears if the
appears if the software is not
systems" on page 32)."
to