Download Print this page

HP A1353A User Manual: Reconfiguring The Agent On Hp-ux Operating Systems; Uninstalling Components From Windows® Systems; Uninstalling Components From Linux Systems; Uninstalling Components From Hp-ux Systems

Ups management module.
Hide thumbs


From the directory that contains all five files, run ./SetupRA -s -f DevManRA.ini to install
If the .ini file is not located in the same folder as the SetuprRA file, run ./SetupRA -s -f
<path> DevManRA.ini, where <path> is the DevManRA.ini file location.
The following command line parameters can be specified and are applicable for both interactive and
silent modes.
-f DevManRA.ini

Reconfiguring the agent on HP-UX operating systems

To reconfigure the management module IP address or serial path, run /sbin/init.d/DevMan setup.
Uninstalling components from Windows® systems
Click Start>Settings>Control Panel.
Open Add/Remove Programs.
Select UPS Power Protection Agent, and then click Change/Remove.
The uninstall wizard launches.
Select Remove Choice, and then click Next.
Follow the prompts in the uninstall wizard to uninstall the software.

Uninstalling components from Linux systems

Execute the uninstall script (./Uninstall).

Uninstalling components from HP-UX systems

Execute the uninstall script (./Uninstall).
Performs a silent install.
Creates an installation log
(opt/DevMan/install.log). Default is disabled for
interactive mode and enabled for silent mode. The
installation log is created automatically for
Windows® during silent installations in
Specifies a configuration .ini file used for clean
installs. When this option is specified, the device
detection and configuration step is omitted.
Some files might remain following the uninstallation and can be removed manually.
Some files might remain following the uninstallation and can be removed manually.
Installing the HP UPS Power Protection Agent 39


   Related Manuals for HP A1353A

Comments to this Manuals

Symbols: 0
Latest comments: