Separation Of Ts Mech Section - Canon DC10 E Service Manual

1-13 Separation of TS Mech Section

(1) Open the Disc Cover.
(2) Remove four screws (b × 1, c × 1, f × 1, g × 1), and detach the TS Mech Section, the Tripod Base, and the Gap Sheet.
Note : After detaching the TS Mech Section, place it with its Lens part upward. Never touch the Lens part.
<Note on Reassembling>
(1) Attach the TS Mech Section as shown in the figure below.
(2) Attach the Gap Sheet to the position indicated in the figure below. (DC10 E only)
c
b
4.5mm
6mm
Metal
Metal
M1.7
M1.7
g
5.5mm
Metal
M1.7
(self tap)
(2) - g
(2) - f
(2)
Tripod Base
(2)
DC10 E only
Gap Sheet
Note on Reassembling (1)
Attach the
Tripod Base.
f
4.5mm
Metal
M1.7
(self tap)
Note on Reassembling (2)
Attachment
reference
(2)
Attachment
reference
TS Mech Section
Adjust to
the notch.
Insert it in advance.
(2)
(2) - c
DC10 E
only
Gap Sheet
Tripod Base
Attachment
reference
Note
Fig. 19
22
DC10 E, DC20 E
DISASSEMBLING
(1)
(2) - b
(2) - b
Lens part