Canon DC10 E Service Manual page 96

<Note on Reassembling>
(1) Attach the Open Knob and the Open Knob Spring as shown in the figure below.
(2) Attach the Lock Base Sheet to the position indicated in the figure below.
(3) Solder the SW FPC Ass'y to the Gear Motor and attach them as indicated in the figure below.
(4) Attach the Gap Sheet to the position indicated in the figure below.
Note on Reassembling (1)
Open Knob
Lock Ass'y
Mount the Open
Knob Spring.
Note on Reassembling (3)
D Cover Switch
Dowels
Align with the dowels at two places.
Eject Switch
Align with the dowels at two places.
Note on Reassembling (4)
AV Holder
A
B
Lock Ass'y
While compressing the Open
Knob Spring, insert the Open
Knob sections A and B into
the slit of Lock Ass'y.
Dowels
Gap Sheet
Attach to the center
on the wall surface
of the AV Holder.
Fig. 32
35
Note on Reassembling (2)
Lock Base Sheet
Attachment
reference
Make them hit by
the standing sections.
Lock Ass'y
Insert
Bend the
flexible cable.
Dowel
Dowel
Align with the dowels at two places.
DC10 E, DC20 E
DISASSEMBLING
Solder
Solder