Canon DC10 E Service Manual page 107

<Note on Reassembling>
(1) Attach the CVF Panel Holder 2, the CVF LCD, and the CVF Panel Holder 1 as shown in the figure below.
(2) Attach the CVF Reflector as shown in the figure below.
(3) The CVF PCB should be attached with the CVF SUB FPC mounted, as indicated in the figure.
(4) Attach the UL Tape to the position indicated in the figure below.
(5) Before using the CVF SUB FPC supplied as a service part, provide preliminary folding at the position indicated in the figure below.
<Instruction for Supply>
Sliding Rail section of CVF Inner Case : Hanarl KS-39M (DY9-3053-000)
Note on Reassembling (1)
CVF Panel Holder 2
The step difference side
should face the CVF Panel
Holder side.
CVF Panel Holder 1
Note on Reassembling (3)
CVF PCB
D
CVF SUB FPC
Dowel
Insert the claws and dowels at the section C,
and then push in the section D and fix it.
Note on Reassembling (5)
Folding in a
trough form
CVF PCB
CN4101
CVF LCD
Insert to the inside of the rib.
Note on Reassembling (4)
C
Dowel
CN4102
SUB PCB
CN1501
Fig. 43
46
Note on Reassembling (2)
Pass the CVF
LCD through
the hole.
Fold the Flexible cable of the CVF LCD.
CVF PCB
Attachment
reference
Fix the flexible cable with
UL Tape (9 × 20mm)
Instruction for Supply
Sliding Rail section
of CVF Inner Case,
8 points.
DC10 E, DC20 E
DISASSEMBLING
CVF Reflector
CVF Cushion
Attachment
reference
Hanarl : KS-39M