Canon DC10 E Service Manual page 99

<Note on Reassembling>
(1) Attach the LCD Ass'y as shown in the figure below.
(2) Attach the Hinge Plate as shown in the figure below.
(3) Attach the Right Sponge as shown in the figure below.
Note on Reassembling (1)
Attach the LCD Ass'y and while
holding the upper section of the
Hinge, attach two screws (3) - k .
Hinge Gap Cover
Pass the flexible cable through
under the lower plate.
Note on Reassembling (3)
(3)
Close
(3)
Right Sponge
Fig. 35
38
Note on Reassembling (2)
LCD Hinge
Cable
Battery Terminal
With the LCD Ass'y closed, pass the LCD
Hinge Cable through the Battery Terminal,
and attach the Hinge Plate so that its holes
are aligned with the dowels.
While folding the Right Sponge
as indicated in the figure, attach
it at the position shown in the
figure.
DC10 E, DC20 E
DISASSEMBLING
Hinge Plate
Dowels