Com-Dc Level Adjustment - Canon DC10 E Service Manual

5-8-3 COM-DC Level Adjustment

MODE Display of monochrome master
M. EQ. Oscilloscope
TP/TRIG. Extension connector - pin 18 (EVF COM DC) / TP signal (self TRIG)
SPEC. 2.30 ± 0.05 [V] (DC. P-P center of EVF COM to GND level)
Procedure)
(1) Carry out adjustment according to the table shown below.
ST EP
COM-DC Level 1) Make the setting shown at right.
Ajustment 2) Perform storing.
(press the PAUSE button.)
PROCEDURE
CS
0
±
2.30V 0.05V
Fig. 26
MONIT OR
Function MD ADDR DT
21 ST 0004 "ADJ" Start of setting
RD ADJ Completion of setting
39
DC10 E, DC20 E
SERVICE MODE / ADJUSTMENT
Microcomputer operation