Service Modes; Outline; How To Change Over To Service Mode - Canon DC10 E Service Manual

3. Service Modes

3-1 Outline

(1) The service mode in this equipment uses the wireless remote controller. (To be used in remote control code 2)
* The remote controller furnished with the instrument cannot transfer to the service mode. For this purpose, use the
remote controller (ex. WL-D84) furnished with a conventional product.
(2) For changeover to the service mode, a dedicated tool (CARD, MINI SD, SERVICE MODE: DY9-1406-000) is required in addition
to the wireless remote controller.
(3) Mode changeover is available between the service mode and the normal mode using the "Audio dubbing" and "SLOW" keys of the
wireless remote controller.
As long as power is ON, the service mode is available even if the "CARD, MINI SD, SERVICE MODE" is removed.
(4) In the service mode, changeover of the main unit operation mode can be handle using the keys on the main unit and the attached
remote controller, but the usable keys are restricted.
(5) In the service mode, safety function such as for low voltage detection is canceled.
(6) On the Index screen in the motion picture playback mode, it is not possible to changeover to the service mode due to the system
mechanism. During playback, changeover to the service mode is available.

3-2 How to Change Over to Service Mode

(1) Set the Service Mode Card (DY9-1406-000) in the card slot
on the equipment and change over to the camera mode.
(2) Press the "Dubbing" key on the wireless remote controller
(WL-D84) that is set at Remote controller code 2.
* To changeover to Remote controller code 2, press
"Remote controller setting" and "Zoom T" keys si-
multaneously for 2 sec.
(3) Now the changeover to the service mode has been completed
and the SERVICE MODE appears on the screen.
* Pressing the "SLOW" key performs the changeover
to the normal mode from the service mode.
As long as the power supply is ON, the service mode
is available by setting the "Audio dubbing" key even
if the Service Mode Card is removed.
* After completion of repairing, press the Reset but-
ton to release the service mode completely.
SERVICE MODE / ADJUSTMENT
Fig. 3
Fig. 4
3
DC10 E, DC20 E
DY9-1406-000