Canon DC10 E Service Manual page 88

<Note on Reassembling>
(1) Attach the Barrier Slide Holder as shown in the figure below.
(2) Attach the LED Radiator Gum to the position indicated in the figure below. (DC20 E only)
(3) The Back Barrier Plate should be mounted as shown in the figure. After mounting it, slide the Barrier Slide Holder to check if the
Barrier opens/closes smoothly.
(4) Attach the Blindfold Sheet to the position indicated in the figure below.
Note on Reassembling (1)
Barrier Slide Holder
Mount the Barrier Slide Holder with its convex
section inserted to the Barrier Arm Ass'y hole.
Note on Reassembling (3)
Adjust to
the dowel.
Pass the flexible
cable through it.
Back Barrier Plate section
Barrier Arm Ass'y
Note on Reassembling (4)
The edge part of the
flexible cable should
be positioned on the
Blindfold Sheet.
Fold the FRONT
FPC, and attach
the Blindfold Sheet.
Fig. 24
27
Note on Reassembling (2)
LED Radiator Gum
FRONT FPC
Blindfold Sheet
DC10 E, DC20 E
DISASSEMBLING
FRONT FPC
DC20 E only
Flexible cable
Adjust to
the step
difference.