Canon DC10 E Service Manual page 82

<Note on Reassembling>
(1) Attach the Main Spacer to the position indicated in the figure below.
(2) Ensure that the GYRO FPC and the FLASH FPC are installed in the direction shown in the figure.
(3) Attach the UL Tape to the position indicated in the figure below.
Note on Reassembling (1)
Main Spacer
Note on Reassembling (2)
MAIN PCB
CN1201
FLASH FPC
FLASH PCB
CN 500
IC100
Attach the Main Spacer
to the IC100 in alignment
with the center position.
Allowable attachment
deviation: ±0.5 mm
GYRO PCB
CN1601
GYRO FPC
MAIN PCB
CN103
MAIN PCB
Note on Reassembling (3)
Screw hole should
not be covered.
Fig. 18
21
DC10 E, DC20 E
DISASSEMBLING
UL Tape (9 × 10mm)
CN107