Setting Up Usb Communications; Setting Up Serial Communications - Intermec PB22 User Manual

Setting Up USB Communications

Setting Up Serial Communications

PB22/PB32 Mobile Label and Receipt Printer User's Guide
• Send the following commands to set a certificate and enable
validation:
setup "8021x","CA_CERT","c:/test.pfx@export"
setup "8021x","VALIDATE","ON"
where c:/test.pfx is the location and name of the certificate and
export is the passphrase.
• Send the following commands to set a common name for
server 1 and server 2:
setup "8021x",".SERVER_CN1","xxxxxxxxxx"
setup "8021x",".SERVER_CN2","xxxxxxxxxx"
where xxxxxxxxxx can be a value from 0 to 64 characters.
• Send the following command to make sure your values match
those used by the access point:
setup write "8021x","uart1:"
You may need to send the following command several times for
•
the wireless station to connect:
setup "wlan","ACTIVE","1"<ETX>
To set up USB communications with your PC, you will need:
• USB cable
• Intermec InterDriver® software
You can download the InterDriver software from the Intermec web
site at www.intermec.com.
Use a serial cable (P/N 075497-xxx) to connect the PB22/PB32 to a PC
or a mobile computer. For the mobile computer, you may need to
purchase a serial adapter. For more information, contact your local
Intermec sales representative.
Chapter 2 — Configuring the PB22/PB32
37