Intermec PB2 Series Instructions
Protective case instructions
Hide thumbs
Also See for PB2 Series:
- User manual (38 pages) ,
- Quick start manual (2 pages) ,
- Supplementary manual (2 pages)
Advertisement
PB 2X |PB 3X
Protective Case Instructions
Use the protective case to transport and store your PB2X and PB3X printer.
The protective case provides easy access to the printer buttons, connectors,
and battery, allowing you to print labels while the printer is still in the
protective case. Use the handstrap or shoulder strap accessory with the
protective case to make it easy to carry. The protective case kit contains these
parts:
•
Protective case accessory
•
This instruction sheet
To detach the belt clip from the printer
1
Rotate the belt clip 180 degrees and pull it away from the printer.
2
Remove the two Phillips screws on the back of the printer.
Advertisement
Table of Contents
Related Manuals for Intermec PB2 Series
Summary of Contents for Intermec PB2 Series
- Page 1 PB 2X |PB 3X Protective Case Instructions Use the protective case to transport and store your PB2X and PB3X printer. The protective case provides easy access to the printer buttons, connectors, and battery, allowing you to print labels while the printer is still in the protective case.
- Page 2 USB cable, or a serial cable to the printer. Worldwide Headquarters 6001 36th Avenue West Everett, Washington 98203 U.S.A. tel 425.348.2600 fax 425.355.9551 www.intermec.com © 2010 Intermec Technologies Corporation. All rights reserved. PB2X and PB3X Protective Case Instructions *943-223-002* P/N 943-223-002...
Need help?
Do you have a question about the PB2 Series and is the answer not in the manual?
Questions and answers