Intermec PB22 User Manual page 37

PB22/PB32 Mobile Label and Receipt Printer User's Guide
The PB22/PB32 cannot initiate a Bluetooth connection. One of the
devices, must request a connection with the printer. The PB22/PB32
then accepts or rejects the connection. Use Intermec Settings on the
mobile computer to enable the Bluetooth settings on the PB22/PB32.
The PB22/PB32 can also connect to Bluetooth scanners, such as the
SF51 and the SR61. You can create the bar code labels you need to
connect the printer to a Bluetooth scanner using EasySet software. If
you are going to create the bar code labels using EasySet, you will need
to know the Bluetooth Device Address and the PIN of the PB22/PB32.
You can download a free version of EasySet from the Intermec web
site at www.intermec.com.
Each PB22/PB32 equipped with a Bluetooth radio has a unique
Bluetooth Device Address (BDA) loaded into its module when
manufactured. You can find the BDA on the certification label located
on the bottom of the printer.
To set up Bluetooth communications with a mobile computer
Follow the procedure to discover and connect to Bluetooth devices
•
in your mobile computer user's manual.
Note: For maximum security, you need to configure a Bluetooth
passcode for the PB22/PB32. The default passcode for the PB22/PB32
is "1234."
To set up Bluetooth communications with a scanner
1 Download and install EasySet.
2 Create the following bar code labels using EasySet:
• Administrator reset factory defaults
• Bluetooth parameters - security - not active
• Bluetooth parameters - connect/disconnect - compose BT
address
• Bluetooth parameters - security - compose PIN
Chapter 2 — Configuring the PB22/PB32
29