Setting Up Usb Communications; Setting Up Serial Communications - Intermec PB50 User Manual

Chapter 2 — Configuring the PB50

Setting Up USB Communications

Setting Up Serial Communications

36
where xxxxxxxxxx can be a value from 0 to 64 characters.
• Send the following command to make sure your values match
those used by the access point:
setup write "8021x","uart1:"
• You may need to send the following command several times for
the wireless station to connect:
setup "wlan","ACTIVE","1"<ETX>
To set up USB communications with your PC, you will need:
• USB cable
• Intermec InterDriver® software
You can download the InterDriver software from the Intermec web
site at www.intermec.com.
Use a serial cable (P/N 075497-001) to connect the PB50 to a PC or a
mobile computer. For the mobile computer, you may need to
purchase a serial adapter. For more information, contact your local
Intermec sales representative.
Before you can establish a serial connection, you need to make sure
that the settings on the PC or mobile computer match those of the
PB50.
Serial Port Settings on the PB50
Parameter
Baud rate
Data bits
Parity
Stop bits
Flow control
Default Setting
115200
8
None
1
XON_XOFF (IPL)
RTS/CTS (ESC/P)
PB50 Mobile Label and Receipt Printer User's Guide