Table of Contents
Advertisement
GX — End of job
HA — Set mode
HC — Next image address
6-8
The GX command initiates the scanner End of Job sequence.
This sequence includes:
• turning off the feeder
• flushing the transport
• turning off the transport
• disabling scanning
NOTE: The image buffer is not cleared.
Data Field
none
The HA command changes the current scanner configuration to
the configuration defined by the specified application mode.
Data Field
mode
Data Field
mode
mode number
NOTE: Only one Set Mode command may be sent with each SCSI
Send command.
The HC command sets the image address for the next document.
Data Field
STX
image address
Data
Field
STX
start of transmission indicator
Image
the image address which is to be
Address
assigned to the next document
ETX
end or transmission indicator
NOTES:
• The image address format must be compatible with the current
application mode. It must be sent to the scanner as if it were
entered on the scanner operator control panel. It should only be
sent when the scanner is idle.
• STX and ETX are optional when specifying numeric-only image
addresses. If the image address contains upper-case alphabetic
characters, STX and ETX must be used.
Command Field
G
Command Field
H
Description
Command Field
ETX
H
Description
X
A
Value(s)
1–18
C
Value(s)
02H
see
NOTES
03H
A-61124 March 1999
Advertisement
Table of Contents
